Aoc 203P Instrukcja Użytkownika

41G2001-615-1A 英文

FRONT PANEL CONTROL • Power Button / Power Indicator: Press this button to turn the monitor ON or OFF. Blue — Power On mode. Orange — O

HOW TO ADJUST A SETTING 1. Press the MENU-button to activate the OSD window. 2. Press < or > to navigate through the functions. Once the

ADJUSTING THE PICTURE The descriptions for function control LEDS Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Icon Description Reset ValueC

H. Position Adjust the horizontal position of the OSD.50 V. Position Adjust the verticalposition of the OSD. 50 OSD Setup OSD Timeout Adjust the OSD

PLUG AND PLAY Plug & Play DDC2B Feature This monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It allows the

TECHNICAL SUPPORT (FAQ) Problem & Question Possible Solution Power LED is not on *Check if the Power Switch is in the ON position *Power Cord

Screen image is not centered or sized properly. *Adjust pixel frequency (CLOCK) and FOCUS or press hot-key (AUTO). Picture has color defects (white

ERROR MESSAGE & POSSIBLE SOLUTION CABLE NOT CONNECTED : 1. Check that the signal-cable is properly connected , If the connector is loose, ti

APPENDIX SPECIFICATIONS Driving system TFT Color LCD LCD Panel Size 51cm(20") Pixel pitch 0.255mm( H )x 0.255mm( V ) Viewable angle17

Switch • Source • Auto Config / Exit • ∧ / Brightness • ∨ / Contrast • Menu / Enter • Power Button External Controls: Functions • Contrast • B

TABLE OF CONTENTS FOR YOUR SAFETY -------------------------------------------------- 1 SAFETY PRECAUTIONS ----

Preset Display Modes STANDARD RESOLUTIONHORIZONTAL FREQUENCY(KHZ)VERTICAL FREQUENCY(HZ)IBM DOS 720 × 400 31.47 70.0 640 × 480 31.47 60.0 VGA 640

CONNECTOR PIN ASSIGNMENT 1561011 15 15 - Pin Color Display Signal Cable PIN NO. DESCRIPTION PI N NO. DESCRIPTION 1. Video-Red 9. +5V 2. Vid

2141G2001-615-1A 英文

2 Before operating the monitor, please read this manual thoroughly. This manual should be retained for future reference. FCC Class B Radio Frequency

PRECAUTIONS z Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. z Do

SPECIAL NOTES ON LCD MONITORS The following symptoms are normal with LCD monitor and do not indicate a problem. NOTES • Due to the nature of the f

INSTALLATION INSTRUCTIONS SWIVEL BASE Install Remove Figure 1 Installing and Removing the Swivel Base PO

CONTROLS AND CONNECTORS VIDEO CABLE Connecting the signal Cable: Connect one end of the 15-pin D-Sub cable to the back of the monitor and connect

ADJUSTING THE VIEWING ANGLE • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to your

OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS Press the power button to turn the monitor on or off. The other control buttons are located on the fr